1 files changed, 30 insertions, 0 deletions
diff --git a/conf/distro/include/arm-thumb.inc b/conf/distro/include/arm-thumb.inc
new file mode 100644
index 0000000..75ed978
--- /dev/null
+++ b/conf/distro/include/arm-thumb.inc
@@ -0,0 +1,30 @@
+#tune file for thumb instructions
+
+ARM_INSTRUCTION_SET ?= "arm"
+# "arm" "thumb"
+#    The instruction set the compiler should use when generating application
+#    code.  The kernel is always compiled with arm code at present.  arm code
+#    is the original 32 bit ARM instruction set, thumb code is the 16 bit
+#    encoded RISC sub-set.  Thumb code is smaller (maybe 70% of the ARM size)
+#    but requires more instructions (140% for 70% smaller code) so may be
+#    slower.
+
+THUMB_INTERWORK ?= "no"
+# "yes" "no"
+#    Whether to compile with code to allow interworking between the two
+#    instruction sets.  This allows thumb code to be executed on a primarily
+#    arm system and vice versa.  It is strongly recommended that DISTROs not
+#    turn this off - the actual cost is very small.
+
+OVERRIDE_THUMB = "${@['', 'thumb:'][bb.data.getVar('ARM_INSTRUCTION_SET', d, 1) == 'thumb']}"
+OVERRIDE_INTERWORK = "${@['', 'thumb-interwork:'][bb.data.getVar('THUMB_INTERWORK', d, 1) == 'yes']}"
+OVERRIDES_prepend_arm =. "${OVERRIDE_THUMB}${OVERRIDE_INTERWORK}"
+
+#    Compiler and linker options for application code and kernel code.  These
+#    options ensure that the compiler has the correct settings for the selected
+#    instruction set and interworking.
+ARM_INTERWORK_M_OPT = "${@['-mno-thumb-interwork', '-mthumb-interwork'][bb.data.getVar('THUMB_INTERWORK', d, 1) == 'yes']}"
+ARM_THUMB_M_OPT = "${@['-mno-thumb', '-mthumb'][bb.data.getVar('ARM_INSTRUCTION_SET', d, 1) == 'thumb']}"
+
+TARGET_CC_ARCH_append_arm =.  " ${ARM_INTERWORK_M_OPT} ${ARM_THUMB_M_OPT}"
+TARGET_CC_KERNEL_ARCH_append_arm  =. " -mno-thumb-interwork -mno-thumb"