From: David Brownell Minor cleanups to omap 2430/34xx/35x musb_hdrc init: - num_eps is 16; here, each one is bidirectional - use DMA_32BIT_MASK to prevent confusion/errors - initialize root port power to reflect 100 mA limit This still hard-wires some board-specific data, since there are no hooks through which different boards can provide the right data to the init code. Signed-off-by: David Brownell --- a/arch/arm/mach-omap2/usb-musb.c +++ b/arch/arm/mach-omap2/usb-musb.c @@ -21,12 +21,15 @@ #include #include #include +#include + #include -#include + #include #include #include +#include #include #ifdef CONFIG_USB_MUSB_SOC @@ -109,7 +112,7 @@ static struct musb_hdrc_config musb_config = { .dyn_fifo = 1, .soft_con = 1, .dma = 1, - .num_eps = 32, + .num_eps = 16, .dma_channels = 7, .dma_req_chan = (1 << 0) | (1 << 1) | (1 << 2) | (1 << 3), .ram_bits = 12, @@ -129,16 +132,22 @@ static struct musb_hdrc_platform_data musb_plat = { : "usbhs_ick", .set_clock = musb_set_clock, .config = &musb_config, + + /* REVISIT charge pump on TWL4030 can supply up to + * 100 mA ... but this value is board-specific, like + * "mode", and should be passed to usb_musb_init(). + */ + .power = 50, /* up to 100 mA */ }; -static u64 musb_dmamask = ~(u32)0; +static u64 musb_dmamask = DMA_32BIT_MASK; static struct platform_device musb_device = { .name = "musb_hdrc", .id = -1, .dev = { .dma_mask = &musb_dmamask, - .coherent_dma_mask = 0xffffffff, + .coherent_dma_mask = DMA_32BIT_MASK, .platform_data = &musb_plat, }, .num_resources = ARRAY_SIZE(musb_resources), -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html